IT認定試験は現在の社会で、特にIT業界で最も人気のある試験だと考えられています。IT認定試験の認証資格は国際社会で広く認可されています。昇進したく、昇給したく、あるいは単に自分の仕事スキルを向上させたいなら、IT認定試験を受験して資格を取得するのはあなたの最もよい選択です。どうですか。あなたもきっとそう思うでしょう。ですから、躊躇しないではやく試験を申し込みましょう。Ciscoの642-642認定試験は最近最も人気のある試験ですから、受験したいのですか。試験に準備する方法がわからない場合、IT-Passports.comは教えてあげます。IT-Passports.comで、あなたは試験に関するすべての優れた参考書を見つけることができます。
Ciscoの642-642認定試験は人気があるIT認証に属するもので、野心家としてのIT専門家の念願です。このような受験生は642-642認定試験で高い点数を取得して、自分の構成ファイルは市場の需要と互換性があるように充分な準備をするのは必要です。
Ciscoの642-642は専門知識と情報技術の検査として認証試験で、IT-Passports.comはあなたに一日早くCiscoの認証試験に合格させて、多くの人が大量の時間とエネルギーを費やしても無駄になりました。IT-Passports.comにその問題が心配でなく、わずか20時間と少ないお金をを使って楽に試験に合格することができます。IT-Passports.comは君に対して特別の訓練を提供しています。
IT-Passports.com を選択して１００％の合格率を確保することができて、もし試験に失敗したら、IT-Passports.comが全額で返金いたします。
試験番号：642-642問題集
試験科目：Cisco 「Quality of Service (QoS)」
問題と解答：全87問
Cisco 642-642認証試験を通るために、いいツールが必要です。Cisco 642-642認証試験について研究の資料がもっとも大部分になって、IT-Passports.comは早くてCisco 642-642認証試験の資料を集めることができます。弊社の専門家は経験が豊富で、研究した問題集がもっとも真題と近づいて現場試験のうろたえることを避けます。
Cisco 642-642認証はIT業界にとても重要な地位があることがみんなが、たやすくその証本をとることはではありません。いまの市場にとてもよい問題集が探すことは難しいです。でも、IT-Passports.comにいつでも最新な問題を探すことができ、完璧な解説を楽に勉強することができます。
多くの時間と労力をかかってCiscoの642-642認定試験に合格するを冒険にすると代わりIT-Passports.comが提供した問題集を利用してわずか一度お金かかって合格するのは価値があるでしょう。今の社会の中で時間がそんなに重要で最も保障できるIT-Passports.comを選ばましょう。
購入前にお試し,私たちの試験の質問と回答のいずれかの無料サンプルをダウンロード：http://www.it-passports.com/642-642.html
NO.1 In an unmanaged CE router implementation, how does the service provider enforce the SLA?
A. by using class-based policing on the CE to PE link to limit the customer's input rate
B. by marking on the CE to PE link and using CBWFQ and CB-WRED on the PE to P link
C. by marking on the CE to PE link and using class-based policing on the PE to P link
D. by using class-based random discard on the CE to PE link to limit the customer's input rate
Answer: A
Cisco認証試験 642-642 642-642問題集 642-642参考書
NO.2 LAB
A. Please click console
Answer:
2950.SWITCH>en
2950-SWITCH#config terminal
2950-SWITCH(config)#int fa0/1
2950-SWITCH(config-if)#mls qos trust dscp
2950-SWITCH(config-if)#exit
2950-SWITCH(config)#int fa0/11
2950-SWITCH(config-if)#mls qos trust cos
2950-SWITCH(config-if)#exit
2950-SWITCH(config)#int fa0/10
2950-SWITCH(config-if)#mls qos trust cos
2950-SWITCH(config-if)#mls qos trust device cisco-phone
2950-SWITCH(config-if)#exit
2950-SWITCH(config)#exit
2950-SWITCH#copy run start
NO.3 Answer:
NO.4 What is the purpose of the qos pre-classify command?
A. to enable the IOS to copy the ToS field from the original IP header to the outer tunnel IP header
B. to enable the IOS to copy the ToS field from the outer tunnel IP header back into the original IP header
C. to enable the IOS to classify the packet based on the original IP header instead of the tunnel IP header
D. to enable the IOS to classify the packet based on the outer tunnel IP header instead of the original IP
header
E. to enable class-based marking on tunnel interface
F. to enable class-based marking on IPSec crypto maps
Answer: C
Cisco練習問題 642-642 642-642 642-642参考書 642-642
NO.5 Refer to the exhibit.
Which three statements are true about the configuration.? (Choose three.)
class-map class-1
match ip rtp 2024 1000
class-map class 2
match dscp 5 6 7
policy-map access-group-1-traffic
class class-1
shape peak 16000
class class-2
police 8000 1000
conform-action set-dscp-transmit 1
exceed-action set-dscp-transmit 0
violate-action drop
class class-default
fair-queue 16
queue-limit 20
interface fastethernet 0/0
service-policy output access-group1-traffic
A. Traffic that is subject to shaping can burst up to 32,000 bps.
B. IP traffic (DSCPs 5, 6, and 7) that is sent on fastethernet 0/0 will be traffic policed.
C. RTP traffic (ports 2024 and 1000) that is sent on fastethernet 0/0 will be traffic shaped.
D. Traffic that is subject to policing will have the DCSP set to 0 if the rate exceeds 1000 bps.
E. IP traffic (DSCPs 1, 2, 3, and 4) that is sent on fastethernet 0/0 are considered to have a violate status
and are dropped.
F. IP traffic (DSCP 0) that is sent on fastethernet 0/0 will be subject to fair queuing.
Answer: ABF
Cisco認定証 642-642認証試験 642-642
NO.6 Which QoS mechanism calculates the mean queue depth to determine its operation?
A. WRED
B. LLQ/CBWFQ
C. WFQ
D. class-based shaping
E. class-based policing
Answer: A
Cisco参考書 642-642参考書 642-642
NO.7 What is the purpose of using multiactions traffic policing?
A. so that exceed traffic can be shaped and violate traffic can be policed
B. so that conform, exceed, and violate traffic can be marked with different CLPs
C. so that conform traffic from different flows can be marked with different DSCPs
D. so that class-based policing can mark at Layer 2 and Layer 3 at the same time
E. so that traffic can be policed using two separate rates
Answer: D
Cisco参考書 642-642 642-642練習問題 642-642認証試験
NO.8 In which two locations is the qos pre-classify command applied to support QoS preclassification over an
IPSec/GRE tunnel? (Choose two.)
A. the tunnel interface
B. the physical interface
C. the crypto map
D. the policy-map
E. the class-map
Answer: AC
Cisco 642-642認定試験 642-642認定試験
NO.9 Answer:
NO.10 In a managed CE scenario, the customer's network is supporting VoIP and bulk file transfers.
According to the best practices, which QoS mechanisms should be applied on the WAN edge CE-PE
56-kbps Frame Relay link on the CE outbound direction?
A. WRR, FRTS, FRF.12, and CB-RTP header compression
B. WRR, CB-WRED, CB-Marking, FRF.12, and CB-RTP header compression
C. CBWFQ, CB-WRED, CB-Marking, CB-Policing, and FRTS
D. CBWFQ, FRTS, FRF.12, and CB-RTP header compression
E. LLQ, CB-WRED, CB-Marking, FRTS, FRF.12, and CB-RTP header compression
F. LLQ, CB-WRED, CB-Policing, and CB-TCP and CB-RTP header compressions
Answer: E
Cisco 642-642 642-642
NO.11 What does the following command accomplish?
router(config-pmap-c)# shape fecn-adapt
A. enables the router to lower the shaping rate when BECN bits are received
B. enables the router to lower the shaping rate when FECN bits are received
C. enables the router to respond to FECN bits by creating test frames in the opposite direction with the
BECN bit set
D. enables the router to respond to BECN bits by creating test frames in the opposite direction with the
FECN bit set
E. enables the router to increase the shaping rate when BECN bits are received
F. enables the router to increase the shaping rate when FECN bits are received
Answer: C
Cisco認定試験 642-642 642-642 642-642 642-642認定試験
NO.12 Based on the following 2950 switch configurations, which statement is correct?
no wrr-queue cos-map
wrr-queue bandwidth 20 10 70 1
wrr-queue cos-map 4 5
wrr-queue cos-map 1 0 1 2 3
wrr-queue cos-map 3 6 7
A. Queue 1 is setup as the expedite queue.
B. Queue 2 is setup as the expedite queue.
C. Queue 3 is setup as the expedite queue.
D. Queue 4 is setup as the expedite queue.
E. No queue is setup as the expedite queue.
Answer: E
Cisco 642-642 642-642 642-642 642-642参考書
NO.13 Switch port fa0/2 has been configured to connect an IP phone with an attached PC. Given the set of
commands shown below, where does the trust boundary lie?
interface fa0/2
mls qos trust cos
mls qos trust device cisco-phone
switchport voice vlan 112
A. between the IP phone and the switch
B. between the IP phone and the PC
C. between the access layer switch and the distribution layer switch
D. between the PC port and the LAN port on the IP phone
Answer: A
Cisco認定証 642-642過去問 642-642
NO.14 Which two commands are typically applied to the voice traffic class within a policy-map? (Choose two.)
A. shape peak {bps}
B. priority {kbps}
C. bandwidth {kbps}
D. compress header ip rtp
E. random-detect ecn
F. random-detect dscp-based
Answer: BD
Cisco 642-642参考書 642-642 642-642 642-642
NO.15 The following commands have been configured under the fa0/1 interface on the 2950 switch:
wrr-queue bandwidth 20 1 80 0
mls qos trust cos
mls qos trust device cisco-phone
Voice traffic from the IP phone that is directly connected to the fa0/1 interface is experiencing excessive
delays.
What could be the cause of this problem?
A. The wrr-queue bandwidth weightings are not correct.
B. The default wrr-queue cos-map is being used.
C. The default cos-to-dscp map is being used.
D. The default dscp-to-cos map is being used.
E. The trust boundary configuration is not correct.
Answer: B
Cisco認証試験 642-642 642-642問題集 642-642 642-642認証試験
君はまだCisco 642-642認証試験を通じての大きい難度が悩んでいますか？ 君はまだCisco 642-642認証試験に合格するために寝食を忘れて頑張って復習しますか？ 早くてCisco 642-642認証試験を通りたいですか？IT-Passports.comを選択しましょう！IT-Passports.comはきみのIT夢に向かって力になりますよ。
没有评论:
发表评论