弊社のJuniperのJN0-522勉強資料を利用したら、きっと試験を受けるための時間とお金を節約できます。IT-Passports.comのJuniperのJN0-522問題集を買う前に、一部の問題と解答を無料にダウンロードすることができます。PDFのバージョンとソフトウェアのバージョンがありますから、ソフトウェアのバージョンを必要としたら、弊社のカスタマーサービススタッフから取得してください。
天帝様は公平ですから、人間としての一人一人は完璧ではないです。私のように、以前が努力しなかったので、今は無駄に悩んでいます。現在のIT領域で競争が激しくなっていることは皆は良く知っていますから、みんなはIT認証を通じて自分の価値を高めたいです。私もそう思いますが、IT認証は私にとって大変難しいです。でも、幸い私はインターネットでIT-Passports.comのJuniperのJN0-522試験トレーニング資料を見つけました。それを手に入れてから私は試験に合格する自信を持つようになります。IT-Passports.comのJuniperのJN0-522試験トレーニング資料のカバー率がとても高いですから、自分で勉強するよりずっと効率が高いです。あなたもIT業種の一人としたら、ためらわずにIT-Passports.comのJuniperのJN0-522試験トレーニング資料をショッピングカートに入れましょう。IT-Passports.comはきっとあなたが成功への良いアシスタントになります。
試験番号：JN0-522問題集
試験科目：Juniper 「FXV,Associate (JNCIA-FWV)」
問題と解答：全160問
難しいJN0-522認定試験に合格したいなら、試験の準備をするときに関連する参考書を使わないとダメです。自分に合っている優秀な参考資料がほしいとしたら、一番来るべき場所はIT-Passports.comです。IT-Passports.comの知名度が高くて、IT認定試験に関連するいろいろな優秀な問題集を持っています。それに、すべてのJN0-522試験問題集に対する無料なdemoがあります。IT-Passports.comのJN0-522問題集があなたに適するかどうかを確認したいなら、まず問題集のデモをダウンロードして体験してください。
IT-Passports.comはJuniperのJN0-522認定試験に対して問題集を提供しておるサイトで、現場のJuniperのJN0-522試験問題と模擬試験問題集を含みます。ほかのホームページに弊社みたいな問題集を見れば、あとでみ続けて、弊社の商品を盗作することとよくわかります。ass4Testが提供した資料は最も全面的で、しかも更新の最も速いです。
購入前にお試し,私たちの試験の質問と回答のいずれかの無料サンプルをダウンロード：http://www.it-passports.com/jn0-522.html
NO.1 Click the Exhibit button. In the exhibit, if host A initiates a Web browsing session with host D, and the
E0/1 interface of the SSG 20 is in NAT mode, what will be the source address of the packet arriving at
host D?
A.10.1.1.1
B.10.1.10.5
C.143.45.56.1
D.143.45.56.254
Answer:C
Juniper問題集 JN0-522練習問題 JN0-522認定証 JN0-522認証試験
NO.2 Which ScreenOS CLI policy statement keyword would enable a policy only during specified times, days,
and/or dates?
A.at
B.calendar
C.schedule
D.scheduler
Answer:C
Juniper JN0-522認証試験 JN0-522認定試験 JN0-522
NO.3 Which ScreenOS CLI command would be useful for troubleshooting a policy deny?
A.get flow debug
B.debug flow basic
C.exec flow analysis
D.debug session basic
Answer:B
Juniper JN0-522 JN0-522認定資格 JN0-522
NO.4 What is the purpose of the VLAN1 interface?
A.It provides policy-based NAT for 802.1Q VLANs.
B.It provides an interface that can be used with 802.1Q VLANs in transparent mode.
C.It provides the ScreenOS device with a routable IP address while operating in route mode.
D.It provides an interface that can be used to remotely manage the ScreenOS device while operating in
transparent mode.
Answer:D
Juniper JN0-522 JN0-522 JN0-522問題集 JN0-522参考書
NO.5 Click the Exhibit button. Traffic from the Internet to the partner servers must use a VIP. In the exhibit,
what is true about the configuration of this feature?
A.You cannot use a VIP in this environment.
B.The VIP can be configured on the e0/4 interface.
C.The VIP can be configured in the Corporate or Internet zone using a different subnet than the physical
interface.
D.The VIP will work only if the destination ports in the incoming packet headers are mapped to the same
ports in the Corporate zone.
Answer:A
Juniper認証試験 JN0-522認定試験 JN0-522
NO.6 Which command can you use to view the log of IKE negotiations and results?
A.get event type 536
B.get ike cookie
C.get sa active
D.debug ike basic
Answer:A
Juniper JN0-522 JN0-522認定資格 JN0-522
NO.7 Which ScreenOS CLI command is required to enable a policy during specified times, days, or dates?
A.set time
B.set clock
C.set calendar
D.set scheduler
Answer:D
Juniper JN0-522 JN0-522 JN0-522参考書 JN0-522 JN0-522参考書
NO.8 Which ScreenOS CLI command would be used to view traffic logs?
A.get traffic
B.get log policy
C.get policy log
D.get log traffic
Answer:D
Juniper認定証 JN0-522 JN0-522参考書 JN0-522参考書 JN0-522 JN0-522
NO.9 What are two benefits of configuring a ScreenOS device in transparent mode? (Choose two.)
A.There is no need to reconfigure the IP addresses of routers or protected servers.
B.There is no need to create MIPs or VIPs for incoming traffic to reach protected servers.
C.Policies are easier to create since you do not have to include source and destination IP addresses.
D.The product can support more VPNs and obtain greater throughput because there is less overhead to
manage.
Answer:A B
Juniper JN0-522 JN0-522認定証 JN0-522認定証 JN0-522参考書
NO.10 Click the Exhibit button. In the exhibit, which routing command would allow host A to communicate with
host C? (Note: Assume a route from the SSG 20 to host A's subnet already exists.)
A.set route 0.0.0.0/0 int e0/3 gateway 177.11.56.254
B.set route 1.1.70.0 interface e0/3 gateway 177.11.56.254
C.configure route 1.1.70.0/24 gateway 177.11.56.254 int e0/3
D.set route 1.1.70.0/24 interface e0/3 gateway 177.11.56.254
Answer:D
Juniper JN0-522 JN0-522 JN0-522認定証
NO.11 Assuming factory default settings, which statement describes the minimum requirements for WebUI
management access to the SSG 5?
A.Connect a PC addressed on the 192.168.1.0 subnet to any interface, open a browser and access
192.168.1.1.
B.Terminate the bootup sequence from the console device, open a browser on the console device and
access 192.168.1.1.
C.Connect a PC addressed on the 192.168.1.0 subnet, to the highest numbered interface and open a
browser and access 192.168.1.1.
D.Using the CLI, define an IP address on a physical interface, connect a PC to the interface and open a
browser to the interface address.
Answer:C
Juniper JN0-522 JN0-522 JN0-522認定証 JN0-522
NO.12 Your VPN tunnel does not pass traffic. You run the get ike cookie command and discover that there is no
cookie. Which two should be verified? (Choose two.)
A.routes
B.Phase 1 configuration options
C.Phase 2 configuration options
D.selected quick mode encryption algorithms
Answer:A B
Juniper JN0-522 JN0-522認定資格 JN0-522
NO.13 Which statement is correct about tunnel interfaces?
A.They can have overlapping IP addresses.
B.They need to be configured in the zone where the protected resources reside.
C.They can be unnumbered and used in policy-based translations if the interface is in route mode.
D.They can be unnumbered from any interface residing on the same virtual router as the protected
resources.
Answer:D
Juniper問題集 JN0-522参考書 JN0-522 JN0-522 JN0-522
NO.14 You want to minimize the number of IP addresses, subnets, and policies in use. How should you
configure your tunnel interface?
A.Configure the tunnel interface with an IP address with a 32 bit subnet mask.
B.Configure the tunnel interface with an IP address with a 30 bit subnet mask.
C.Configure the tunnel interface as unnumbered and place the interface in the same zone as the
designated interface.
D.Configure the tunnel interface as unnumbered, but place the tunnel interface in a different zone than the
designated interface.
Answer:C
Juniper練習問題 JN0-522 JN0-522参考書 JN0-522 JN0-522
NO.15 Click the Exhibit button. In the exhibit, what is the correct address book entry for host C?
A.set address C 1.1.70.250/32
B.set address Partner C 1.1.70.250
C.set address Partner 1.1.70.250/32
D.set address Partner C 1.1.70.250/32
Answer:D
Juniper JN0-522練習問題 JN0-522
NO.16 What is the purpose of the "Permitted IP" address on a ScreenOS device?
A.It defines a list of addresses that are trusted to perform management on the ScreenOS device.
B.It is used in policy rules to determine which user traffic is allowed through the ScreenOS device.
C.It defines which range of addresses that can access devices connected to the ScreenOS device.
D.It is the address that an external device uses to gain management access to a ScreenOS device.
Answer:A
Juniper認定試験 JN0-522認定証 JN0-522
NO.17 You enter the following command: set int e0/8 mip 1.1.8.32 host 10.1.10.32 netmask 255.255.255.255
How many MIP address translations have you just configured?
A.1
B.8
C.128
D.256
Answer:A
Juniper過去問 JN0-522 JN0-522問題集 JN0-522 JN0-522認定証 JN0-522認定証
NO.18 Click the Exhibit button. In the exhibit, which two forms of address translation would have generated
the output shown? (Choose two.)
A.MIP
B.NAT-src with no DIP
C.Interface-based translation
D.NAT-src with a DIP, fixed-port disabled
Answer:B C
Juniper過去問 JN0-522 JN0-522 JN0-522練習問題
NO.19 What needs to be configured in Phase 2 of a route-based VPN, that does not need to be configured in a
policy-based VPN?
A.proxy-id
B.tunnel-binding
C.transport mode
D.custom proposals
Answer:B
Juniper練習問題 JN0-522認定試験 JN0-522練習問題 JN0-522認証試験 JN0-522認定資格
NO.20 Click the Exhibit button. In the exhibit, what is the correct command to configure a default route on the
SSG 20?
A.set route 0.0.0.0/0 vrouter untrust
B.set route 0.0.0.0/0 interface e0/4 gateway 143.45.56.254
C.set route 0.0.0.0/0 interface e0/4 next-hop 143.45.56.254
D.set route 0.0.0.0/0 interface 143.45.56.1 gate 143.45.56.254
Answer:B
Juniper認定資格 JN0-522 JN0-522過去問 JN0-522認定証 JN0-522参考書 JN0-522練習問題
JuniperのJN0-522認定試験は競争が激しい今のIT業界中でいよいよ人気があって、受験者が増え一方で難度が低くなくて結局専門知識と情報技術能力の要求が高い試験なので、普通の人がJuniper認証試験に合格するのが必要な時間とエネルギーをかからなければなりません。
没有评论:
发表评论